Wall switch socket basic installation acceptance

Editor:Switch socket manufacturers _ switch socket join agent _ Yuba join agent _ Zhejiang GELAN Electric Co., Ltd. │ Release Time:2019-04-02 

In daily life, to make safe use of electricity, the glitch of those sesame mung bean eyes is not sloppy. The acceptance of the circuit is one of the most important acceptance steps in the acceptance of home decoration. We must carefully check every switch and socket to ensure that it works properly and can be used with confidence. Today, Gelan Xiaobian tells everyone what to check for wall switch socket installation and acceptance.

墙壁开关插座基本安装验收

First, the basic installation acceptance


First check the installation position of the switch and socket, and the installation requirements are stable and stable. The box is completely intact and the cover is close to the wall. In addition, you can cut off the power to open the cover, check the wiring inside the box to meet the requirements, do not hurt the core, the box requires good insulation treatment.


Second, the installation tolerance


When the switch socket bottom plate is installed side by side, the height is required to be equal, and the maximum height difference allowed is not more than 0.5 mm. For all switches in the house, if there are no special requirements, they should be equal in height and the height difference should not exceed 5mm. In addition, the panel can detect the verticality through the pendant line, allowing a deviation of 0.5mm.


Third, check the switch control


The switch is the console for operating electrical equipment, and its normal operation can bring a lot of convenience to our home life. When the circuit is inspected, try to open the test operation for each switch as much as possible to ensure that the switch button is normal and the line is connected normally. For some switch lines that have not been installed, the lamps are installed and accepted.


Fourth, the outlet power check


At this time, it is necessary to use the electroscope, insert the special electroscope into the socket, and then repeatedly switch the switch to check the power-on status of each socket. If the indicator light is all black, there is a problem with the power supply of this outlet, which needs to be repaired.


Five, socket wiring check


In addition to checking that the outlet is energized, you also need to check if the socket is wired incorrectly. Because some sockets may have zero fire line reversed, lack of zero line, lack of ground line, etc., wiring errors are likely to cause circuit accidents. The method of checking whether the wiring is correct is to use the socket detector to judge whether the socket can be energized normally by observing the lighting condition of the N, PE and L lamps on the electroscope.


Sixth, switch socket finished product protection


Finally, the surface is still intact when it is accepted, and any mistakes made during the decoration can be claimed. Keep the wall clean after installing the switch socket. During other constructions, do not touch the switch and socket.


The above 6 points are the installation and acceptance of the wall switch socket, I hope to help you. For more information on switch sockets, please pay attention to GELAN's official website.


CONTACT

Fax:0086-573-83250880 Service Hotline:0086-573-83250886 83250887 Free Service Hotline:400-008-7727 E-mail:gelancn@126.com Address:No. 459, Qingyuan Road, Wangdian Town, Jiaxing City, Zhejiang Province
Follow us

Zhejiang GeLan Electric Co., Ltd.

在线咨询

联系电话

400-008-7727